![]() ![]() the Arduino API method for entering deep sleep requires specification of a timeout, passing a value of 0 disconnects the timer so that the chip will remain in deep sleep indefinitely, until it is woken through an external reset.PIR sensor), you might want to use light sleep instead. If you have a stupid external component (e.g. it is not possible to deactive it while the chip is running! Whatever external device normally triggers wake-up from deep sleep is responsible for not sending the same signal during normal runtime. the RESET pin behaviour is fixed in the hardware, i.e.This pin is internally pulled HIGH and many sources state that reset is triggered by pulling it LOW, but according to my own tests it’s actually the final LOW-to-HIGH transition after having pulled it LOW that causes the reset. waking up from deep sleep is done by resetting the chip via the RESET pin.any pin which was outputting a PWM signal at the time of entering light sleep will stay stuck in whatever digital state it was in at the time of CPU shutdown (i.e.maintains output pin states during sleep but PWM is not working.deep sleep: does not maintain output pin states during sleep.registering a on-wakeup callback void fpm_wakup_cb_func1 () wifi_fpm_set_wakeup_cb ( fpm_wakup_cb_func1 ) Output pin states during sleep ![]() in order to get timer-based light sleep to work correctly, this callback is actually mandatory (see below).optionally one can register a callback method that is invoked on waking (this is run just before the main code continues to execute).light sleep is entered fast, so you might want to flush() any pending output streams before entering it.light sleep only suspends the CPU, so after waking up the code continues to run where it left off. ![]() Up to 508 bytes of user memory can be used to preserve data between sleep cycles (see Arduino documentation of ESP.rtcUserMemoryWrite()/ ESP.rtcUserMemoryRead() and the handy RTCMemory library the Low Power Demo uses memcpy and memset to write/read to RTC)
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |